ok so i know you can change the nuckels and all that fun stuff but does anyone sell a 2 inch spacer that would do the same thing or anythin of that sort
ok sounds good well im out of state at the time and im not sure when ill be back but i see if i can get one of the guys to come pick it up so were exactly are ya?
so is there any one out there that makes a spacer to go from 6 to 8 so i dont have to go scavange for parts again cuz im stuck in elko nv and cant find **** for parts unless could i use my axle out of my 77 chev its only a half ton and im not sure what the pattern is
its back in salt lake
ok ill give it a shot how much do you want for it and how hard is it to get a harness and an ecm cuz i found the whole kit but its way to expensive?
TEDO
ok so i just pulled this motor out of a 1977 chev its a re built motor and runs great but i dont know how well she will do on the trail bein as its carb any ideas on what i should do
ok so i just got a wagy axle out of a 78 wagon and im tryin to see what the best and easiest way is to either change the nuckels or to get some sort of a spacer or somethin so i dont have to run two different sets of wheels?
TEDO