Recent content by cjfj80

Anyone ever tried or used the Rough Country front struts? Seems like a decent inexpensive option….

I'm looking for some stock struts for my 05' Tundra. Don't currently have $$ for new so see if anyone has some take offs laying around. Truck currently has a blown factory Billy 4600 on one side and a cheap Monroe that's near shot on the other. Thanks!

Has anyone been on the White Rim in the last couple weeks? I'm trying to find trail conditions and if it would be okay currently in a stock Sequoia... I am suppose to leave tomorrow to be a support vehicle for some mtbr. Any help would be much appreciated!!

I checked with Toyota and the overload is counted with the pack. I'm think you are right, there is an add-a-leaf in there to get the small lift. Toyota is going to inspect it this week and let me know if they will cover it. Sounds like they will not cover anything if it's been modified at all.

I picked up a 2008 Tacoma recently and was notified that it has an active leaf spring recall. The notice says 3pk and 4pk springs. This truck was lifted before I picked it up and has 5 leafs. How can I tell if these are the recalled springs or aftermarket? The only lettering I can find is an MX...

Sounds good. Thanks for all the help!

Does the wheel dimensions play a part here? These are 16x10 with a 4.5" backspace and from what I can measure with the wheels on the truck still, a zero offset. I'll get those spacers off and probably try and still persuade the body a little. I really don't want to lift higher. For what I do...

The tire measures 30.5" Its just the pinch seam that it is rubbing on but is so close I wonder if it would rub even with the seam flattened. I installed OME 882's on the front and there is a 3/16" shim on the top of the coil. From stock my before and after measurements came out to right around...

I have a 97' 4Runner. 2.5" OME lift. It has 265/75R16's on it that rub when turning over any size bump. Off road its pretty terrible rubbing. It does has an ARB bumper on it and no rubbing there, just on the pinch weld against the cab. I didn't think 265's would give me any trouble. The wheels...

Give me a call and we'll figure out how to get them to you.

I have three set of springs. I've had them on and off various 4Runners in the past. 3rd Gen Runners. One set of FJ80 coils. $10 I don't remember the year but I think you could look up the color pattern. They lifted the Runner 4" or so. Set of I think All-Pro lift springs. $10 I was told by...

I can give that a shot, is the play in the CV where it goes through the hub normal? Could those brass bushing wear out or the needle bearing inside?

Have had a fairly load metal clunking from the front drivers of my 95.5 taco. This truck has factory manual locking hubs. The noise shows up mainly over bumps, rough road, gravel. Everything under there looks tight and feels tight except the cv shaft where it enters the rear of the hub (see...

Thanks for all the input. I went ahead and sealed all the connections and cleaned the ground on the bottom of the winch. Seems to be working great now. Thanks again.

Topper to fit a 95' taco. 6' bed. I can only go up to $200 or so. If you have one sitting around collecting snow, let me know. Thank! Caleb