Recent content by Roktoys84

But with one stock case and 4.7s in one case you can choose between either ratio or go really low if you need to.

I'm ready to start gathering parts to go full width. I'm planning on running a HP44 up front and a 60 rear. I want to keep my 5 on 5.5 lug pattern. What year did the HP44's have the welded radius arm mounts? Or does it even matter? What's the easiest way to go to 5 on 5.5 with discs on a FF60?

Names should be earned, not just given ;)

I'll be there with at least one other rig.

It's on the front window.

So I've decided to ditch the Dana 30 and figured I might as well get rid of the spacers too. I'm going to start looking for a HP Dana 44. I want to keep my 5 on 5.5 pattern. What years had the welded radius arm mounts?

Just want to say thanks to 4X4 Outpost. I broke a draglink on Golden Spike last Sat and we didn't make it back to town untill almost 8. Everybody but Checkers was closed and they didn't have one. We were supposed to leave early Sunday so I ended up calling the Outpost's emergency number. (I...

I ended up taking the Jeep to West Motor in Preston and they had to reset the camshaft/crankshaft timing.

I just went to Checkers and had the code reset and the check engine light came back on before I pulled out of the lot. :mad:

I replaced the crankshaft position sensor this morning and took it for a test drive and the check engine light came back on. It still cuts out at 3000rpm. Would the computer be causing it to cut out? Or is it something else?

What is involved in replacing the crankshaft sensor?

OK, I drove it around yesterday and put some trips on the computer, and disconnected the battery for a few hours. The check engine light was off when I drove to work tonight, for about a mile anyways. The initial code was "camshaft postion sensor intermitant" so we replaced the camshaft position...

My freshly built Unlimited leans to the right also, must be a gansta thing :greg:

Are you still worried about it? We were only joking about the 61 part, it's just to bad you lost the coin toss :rofl:

If I have to have mud flaps I'm gonna pimp them out :D