Search results

No more shower drain clutch ducting. ⁹

I went with osb in my shop for a few reasons. It can take a hammer thrown at it when i have fit, Its easy to install (I hate dry wall work), and i can run a screw about anywhere to hold most things. I'll admit it doesn't look as nice as finished drywall but it doesn't matter to me in my dirty...

New Seats and mounts.

👌

We ran it longer than I would ever run it at one time and the tank only got up to 95*. Plumbing a cooler in the return line would be super simple. It's easy to check the temperature by just feeling the lines so I'm not too worried I'll melt it down. I only went with a 18 ram which is close...

Mmmm butter👌 I was able to feather the hydraulics just as i wanted. I made a shield for the hydraulic fitting, and made a little shelf to hold some of my bending crap.

Yes I remember us talking about yours before. I figured if I wanted a stop switch like yours I easily could wire one in to just shut the pump off like yours does but still be able to feather it with the valve lever.

Heres my old harbor freight set up. I really wanted a central trunnion set up with this new ram so that it wasn't side loading the ram. I would notice the side loading on the harbor freight ram with the offset pivot when the ram was fully extended.

Ive bent a lot of tube with the factory hand crank and the harbor freight air ram mod with this thing and figured it was time to do some up grades with it. We are putting together some production golf kart roll cages and wanted to bend more faster with it. I Ordered the valve size based on a...

I got that cabinet situated and started filling it with crap. Its 56" wide and 28" deep. Then we did smore painting.

Pretty sure each leg gets full breaker amps.

This is what i did inside my welder when i installed the 115 outlets. Did you put a fuse or breaker in line or do you have 30-50 amps to the 115v outlet? Mine has a full 50amps lol.

1" hole through a chunk of 3/4" like butter.

Guess i never posted pics of the first fridge we found in the hills years ago. :mad:

Did some night wheeling with my fren YJ_Auzzy. We found another fridge up in the hills. :mad:

The old lady decided to do some painting, I happily helped the best I could.

Cut me some press plates out of some 1" .

Thank you sir. This iron worker was the last peice of equipment I sought after. I just don't have the room for anything thing else in my 23x42 foot shop. I'm sure that cabinet was expensive for someone. They were asking 50$ for it. I got the cabinet and a pile of vice grips thrown in the...

I made this 3000lb boat anchor movable, and got it wired up. I need to put an amp meter on it to see if my phase converter can keep up with it. Its the biggest hp machine i have now. 7.5hp. Playing with a piece of 4x3/8.

Time will tell