Search results

Do we know what pigtail connects into the advance adapter reluctor wheel? My harness doesn't have a plug for it. The speed is not moving when driving. Stays at 0, can't figure it out. Using Novak tac emulator.

Someone is parting out an 06 Unlimited. Thinking of getting the fuel tank with the sending unit. My understanding is that those out of 05 and 06 are regulated to 58psi..? Can the 06 sending unit fit on 04? Or the whole tank is needed with it?

My fuel level is not moving at all, I just put about 5 gallons gas still not moving, stays on empty with the light on. Also the numbers on the cluster don't light up, probably not related to the Fuel level.

The harness is calling for these plugs. $40 not bad

Did check again, I may have a problem, the space between the shaft and exhaust isn't much at all. I don't rock croll, if that may help, but it's really close.

Are o2 sensors harness dependent? The harness am using is calling for a different o2 sensor? Can someone explain plz

I did think of that when I started. I had the driveshaft, and everything that could be in place installed when building the exhaust. I am also running a 3" suspension lift

I checked and it is very low. Can the fluid be added through dipstick?

Almost finished building the exhaust, 2.5" pipes all around, and go my rear driveshaft shortened. I went with no cats. I don't have the o2 sensors on. I need to get the o2 bungs, drill the holes and weld them in. I got to more the truck for the fist time. I noticed a long delay moving in...

Does it sound like a V8 at all? I like it quiet also but not too too quiet, a like a little exhaust note.

Nothing added

When I bough the jeep, it came with a new, not installed 2.5" tubing dynomax super turno muffler, and the rear tail pipe that is also 2.5". Was thinking of using it, and building the exhaust system with 2.5" tubing all around so that I dont have to bend a new rear section. What are the benefits...

Appreciate the reply. I ask just in case someone on here had to deal with these cats at some point, or similar size. You never know until you ask, plus many have the same engine, trans, frame configuration etc, so it's not that unique. Exhaust shops want $2000+ to put one together, to me that's...

Came across these cats out of a 2014 camero v6, will these work? $200

Possible to see an image of the routing of the exhaust?

Are you using a Jeep Cat or GM ?

Yes, the vin scanned must match the registration. In MA emission test is not require if vehicle is 10+ years old, but I know they still connect to obd2, my guess is to get vin info

Also when going through the inspection, what computer will be scanned? I suppose the Jeep, and need to hide the GM obd2 ?

I was thinking of doing it myself once I source a good pipe bender.

Will have to ask, but I know they want to see some sort of indicator light of what position the shifter is in displayed somewhere around the dash.