Search results

Does it measure 6" center to center.

Any one know the specs on a scout2 pitman arm? I need a pitman arm that is 6" center to center and will fit the jeep tj box and the draglink end taper doesn't matter. Also needs to be flat as in no drop or even a little negative. Anyone have any ideas?

PM sent

Talk to Carl at TeraPlus he will hook you up he is on here as Ilean, and they install these almost daily. I bet they would be the cheapest all around. I would do it for you but I am redoing my whole front suspension/steering/trackbar/coilovers, so I am in the middle of a huge project I am trying...

I spent lots of hours on mine...Lots. Mine was a 2000 Wrangler with the same year donor so had to retain all the sensors. Advanced adapters had a write up on this particular swap look that up it has a lot of info. You just need to graft the dodge engine part of the harness into the Jeep, you...

I had one in one of my TJ's, was able to graft the Dodge harness into my Jeep harness using factory service manuals for each vehicle. Squire hotwire also makes a conversion harness for that application now as well.

Here is your motor! http://www.rockymountainextreme.com/showthread.php?t=70222 Congrats on the rig, killer deal.

Did you delete the ac or did you notch the frame?

Put some heat to the C's and they will turn, sure you cut all of the weld out. Killer rig can't wait to see finished.

Do you mean no carrier at all? If so, pull the front driveline and at least keep the stub shafts bolted into the unit bearings or else they can come apart (the stub shafts hold the bearings together).

Check to see if the rear driveline cv has broken the center pin.

TJ Rubicon flares are 1" wider than the standard TJ flares if that helps.

Nothing too serious, but the dually ended up sunk to the frame.

Thanks for all the links/ Information, I am very eager to get down there!

Can the swell be ran in the winter/ how is it in the snow? Looks like fun that is something I would like to do.

If that sells for that much, I will have to go into business making buggies using a harbor freight bender and blazer drivetrains....

Looks like project "clampy" from Petersons four wheel drive magazine.

Gen right is doing free shipping right now, No sales tax and free shipping direct from them would probably be your best bet. Give them a call the free shipping deal ends soon.

$50.00 Less than Everyone else... Two of those other places were not using genuine spicer parts and I have had nothing but bad luck with that cheap crap, The one place that would use the spicer parts was $100 more than what I paid for mine that B&W built me using genuine spicer parts. 1350 rear...

Found his details here http://www.rockymountainextreme.com/showthread.php?t=69566