Search results

A quick easy way to bend light gauge sheet is to clamp your piece between two pieces of 3/16 or 1/4 in a vise and just fold it over by hand or with a body hammer. If it's too big to fit in a vise, you can clamp the pieces with vise grips. When it comes to welding, fit the pieces as tight as...

Checked the drop pile at work today. No luck

Do you need full twenty foot lengths or twenty feet total in shorter lengths?

Had buddy who had radiant floor heat in his shop, I would never build one without it. Also couldn't agree more with getting the noisy compressor out of the shop in its own little shed, air lines are easy to run and you can put quick connects anywhere. I can get air anywhere in my shop with a...

He listed sources, all of them are tied to the Democratic party. Keep in mind the other half of the story, that one percent also pays ninety percent of all taxes. It is possible for almost anyone to become part of that group if they are willing to give up everything else to work for it. That...

Anything shortened to just the first letter because you are too lazy to type the other one or two letters! Lolrotflmaofswbrbfm

Never used the dingo but it should do all right unless it's really rocky then skid steer is the only way to go

It was good to meet you Casey thanks for coming out

Here's a few pics from yesterday

Milwaukee has a deal going I think it runs through the end of Nov. $100 off if you trade an old drill and two batteries.