dana 60

I have an un-assembled brand new Axle Truss and Hydraulic Cylinder mount for a Chevy Kingpin Dana 60 front axle by Artec Industries. It is brand new and ready to weld. Retail $699

Well, I've moved on from the Willys 2.0 plans and the replacement project is in my possession. Might as well start a build thread! For those that have been on here for 15+ years, you may remember the RME4x4 TJ that I built up, with the help of many companies and the guys at Ben Hanks Racing...

Dana 60 (NOT a d50) front and Sterling 10.5 rear axle out of a 2006 F250. 3.73 gears. Great candidates for your one ton swap. High pinion, driver drop d60 with 1480 ujoints, 35 spline shafts and huge disc brakes; needs hubs and a tie rod. Matching 10.5 rear, also with disc brakes. 8x170 bolt...

Pretty cool, eh!?! I no longer have a 10 minute version of a lockout (drive flanges). These take about 20 seconds. Very similar profile to the drive flanges. Anyway, here's the pics. I did have to read the instructions a little. ALLJEEP.com snagged these early production units and...

Long time over due. My current buggy is now over 6 years old and just doesn't quite fit my family of four. I've considered stretching the old chassis, but the rear radiator design would have just made it to much work. Might as well build a new one! I've been planning this out in my head...

Put a 60 in the front of my F250 this weekend. Un-installing the TTB is a royal PITA....60 went in like it was meant to be there....oh wait, it was! Stupid Ford. However I would HIGHLY suggest having some help when moving a front 60 around!!!! I can barely move today! 60, gravel driveway, no...

I finally went out to the garage and started trimming the brackets off the HP60/70U. I also cut some of the drivers side spring perch off the 60. After hashing it out, I'm going to run coilovers and full hydro in the front. I am going to need 107"-108"wb to run 40s and keep it as...

What's the deal with these? Are they junk? I'm helping out a Iraqi vet that was wounding in service and Teraflex gave hime a BS story about too big of motor, etc. and to get a 14b or Dana 70. The guy is running 35" tires and a mostly stock SBC and he's blowing up gears. The first set the...