2" PIPE bender.....anyone?

[mbryson]

NOT TUBE. Pipe in the 2" flavor (maybe it's 1.75"? because I know I measured 2" on the outside edge).

I need a couple of bends in some PIPE. Sched. 40 (it's pretty thick wall).

Anyone have a pipe bender in the south davis-north salt lake county area?

 

[Bucking Bronco]

I have a Harbor freight Kinker and I also have a 2" die for my tube bender.

Would there be some reason you could not use the tube bender?

 

[mbryson]

I have a Harbor freight Kinker and I also have a 2" die for my tube bender.

Would there be some reason you could not use the tube bender?

If it will fit in the tube bender with your die, I don't know why that wouldn't work out? I'd hate to break a die for someone, though.

 

[Bucking Bronco]

You are more then welcome to borrow both and use which ever you think will work best.

You do have a tube bender. you would just need the Die right.

 

[BCGPER]

You sure about that being 2" pipe? Pipe is usually measured by ID, and I've never heard of 1 3/4" pipe. If it measures 2" OD, it's some type of tube I'd bet.

 

[chadschoon]

ya 2" pipe is more like 2 1/2" 1 1/2" pipe would be closer to 2" od

 

[mbryson]

ya 2" pipe is more like 2 1/3" 1 1/2" pipe would be closer to 2" od

Maybe it's 1.5"?

 

[gijohn40]

if you can wait until next tuesday I think my boss has a 2 inch conduit bender that we use for schedule 40 conduit... he is on vacation and I will be too starting tomorrow...

what do you need a bend in? usually we just go to home depot and buy a prebent elbow and connect it to a straight conduit.... they make the bends in like 90*, 45* and 30*...

 

[CJJ92yj]

2" pipe = 2.375" OD

1-1/2" pipe = 1.9" OD