xjtony
Well-Known Member
- Location
- Grantsville, Ut
Picked up a new rig so I'm letting the project go. I'd like to sell as a project, but will part out if I need to.
Chassis. Built off of a Yota frame. 1.5 DOM. It does need a little repair on the rear, but its a good foundation. The chassis has a Chevy 4.3, set up for OBA, and an orbital for hydro. Its set up for 4 link in the rear and the front can be set up for leafs or link ( I have a set of leafs I will include ).
Turbo 350 and NP205. I got the trans from a shop where I was told it had been rebuilt with a shift kit installed, but I've never opened it up.
JB fab Twin sticks. Never installed
Fuel cell
A bunch of Teraflex Monster joints. There is enough to do the rear, with a few extras.
38 Inch TSLs for 16.5 tire. I have a set of steel wheels that can go with them. I also have 2 low tread spares.
Dana 70s. I don't have any pics. The front, 7.17 gears, 35 spline, drive flanges. The front is complete minus calipers. It will need to be re-tubed (driver drop, and the PO started to cut the tubes to remove the knuckles)
The rear is missing one shaft (advance 4WD should have a replacement or you can get cut to length after market shafts ) 7.17s and 35 spline shafts.
I'm asking $2500 for the whole lot. I would take 39-42 inch tires for a 15 inch wheel and some black Corbeau suspension seats as partial trade.
Chassis. Built off of a Yota frame. 1.5 DOM. It does need a little repair on the rear, but its a good foundation. The chassis has a Chevy 4.3, set up for OBA, and an orbital for hydro. Its set up for 4 link in the rear and the front can be set up for leafs or link ( I have a set of leafs I will include ).
Turbo 350 and NP205. I got the trans from a shop where I was told it had been rebuilt with a shift kit installed, but I've never opened it up.
JB fab Twin sticks. Never installed
Fuel cell
A bunch of Teraflex Monster joints. There is enough to do the rear, with a few extras.
38 Inch TSLs for 16.5 tire. I have a set of steel wheels that can go with them. I also have 2 low tread spares.
Dana 70s. I don't have any pics. The front, 7.17 gears, 35 spline, drive flanges. The front is complete minus calipers. It will need to be re-tubed (driver drop, and the PO started to cut the tubes to remove the knuckles)
The rear is missing one shaft (advance 4WD should have a replacement or you can get cut to length after market shafts ) 7.17s and 35 spline shafts.
I'm asking $2500 for the whole lot. I would take 39-42 inch tires for a 15 inch wheel and some black Corbeau suspension seats as partial trade.
