Currie High 9" Third with ARB

[N8RB8R]

4.88 r&p 31 spline arb 1310 companion flange. Retails for $2075 from Currie

Was only ran on a couple of trips and shows no signs of wear. This was purchased complete straight from Currie.

Changing directions on this build for something portal, so liquidating the 9" parts

This third should work on any 9" housing as a solid upgrade.

Asking $1200 OBO

Call or text 801-360-fortyseventwenty

 

[N8RB8R]

Easy 9" upgrade!

 

[flexyfool]

I've twisted Currie 31 spline shafts with a Currie high pinion third and 4.56 gears. I can testify that it is plenty strong. It also puts the drive shaft higher than a HP 44 or 60 and is meant to be run in the rear axle so there is less chance for the pinion bearings to burn up. Worth the money if you have it to spend.

 

[N8RB8R]

Bumping this back up as I just found it still buried here.

 

[rholbrook]

Calling Tyson. Perfect for your TJ

 

[Cascadia]

Looking into it possibly. Was planning on a 70 but we shall see.