Kiel Formerly WJ ZUK May 7, 2011 #1 Can I assume if on a assembled dana 60 35 spline shaft, the u joint cap spins in the ear of the shaft that the shaft is bad?
Can I assume if on a assembled dana 60 35 spline shaft, the u joint cap spins in the ear of the shaft that the shaft is bad?
RockMonkey Suddenly Enthusiastic May 7, 2011 #2 Yes. So weld the cap on and wheel it. Or weld the cap on and keep it as a spare.
mbryson .......a few dollars more Supporting Member Location Bountiful, land of rocks May 7, 2011 #3 RockMonkey said: Yes. So weld the cap on and wheel it. Or weld the cap on and keep it as a spare. Click to expand... Good advice there
RockMonkey said: Yes. So weld the cap on and wheel it. Or weld the cap on and keep it as a spare. Click to expand... Good advice there
Kiel Formerly WJ ZUK May 7, 2011 #4 Thanks guys, on the search for some aftermarket inner shafts. Also changed the inner axle seals, and found some decent cracks in my welds in the welded carrier.
Thanks guys, on the search for some aftermarket inner shafts. Also changed the inner axle seals, and found some decent cracks in my welds in the welded carrier.
thenag Registered User Location Kearns May 9, 2011 #5 I seam to always have the opposite problem, mine rust in and don't come out. I guess that means I should break them more often... nathan 99 xj on jack stands, next time it is on wheels will be on a 60 and a 14 bolt...
I seam to always have the opposite problem, mine rust in and don't come out. I guess that means I should break them more often... nathan 99 xj on jack stands, next time it is on wheels will be on a 60 and a 14 bolt...
