Dana 70 Pinion Nut....

[Shawn]

So I go to replace the pinion seal on the dana 70 and the sockets I have are to thick.
I's there a place that sells a 1 5/16 thin wall socket?? I think that is the size.. hard to tell when it wont quite fit all the way one.


Unless someone has one I can borrow

Thanks,

 

[bobdog]

I dont know if there are thin ones or not. I am hoping that socket you have is a craftsman not a snapon because I think you will probably be grinding.

 

[Hickey]

So I go to replace the pinion seal on the dana 70 and the sockets I have are to thick.
I's there a place that sells a 1 5/16 thin wall socket?? I think that is the size.. hard to tell when it wont quite fit all the way one.


Unless someone has one I can borrow

Thanks,

I have one that will work.

 

[Shawn]

I have one that will work.

Sweet..



I'll let ya know when I'm ready

 

[Shawn]

Now that I think about it,, I'll bet Six States has one. They have many different sizes in the hub nut area.

 

[Hickey]

Now that I think about it,, I'll bet Six States has one. They have many different sizes in the hub nut area.

You might ask Andy which size it is before you buy. You wouldn't want to go back for the right socket 2 or 3 times.

 

[Shawn]

Found a Thin Wall from Snap-On.....


$36.00

 

[Shawn]

Icky,

What do you have?

 

[Hickey]

Icky,

What do you have?

1-3/16 1-1/8 1-1/2 and a 34mm My 60 front is the 34 mm. My 14 bolt is the 1.5"

 

[Shawn]

1-3/16 1-1/8 1-1/2 and a 34mm My 60 front is the 34 mm. My 14 bolt is the 1.5"

Do you not have a 1 5/16 thin wall??

 

[Hickey]

Do you not have a 1 5/16 thin wall??

no. My 34 MM is VERY close though, just a ---- hair bigger than 1-5/16" , but it is a 6 point.