Early Bronco Project: Ad on KSL.com

[mbryson]

Just ran across this on KSL.com. Looks like a decent start for someone building from the ground up or maybe someone with a crappy/rusty body. It's in Elko, though.

http://www.ksl.com/index.php?nid=218&ad=18560789&cat=102&lpid=7&search=

 

[RockMonkey]

It's hard to tell from the pics, but the fabrication on the cage looks a bit sketchy. None of the tubes are even close to lined up with each other.

 

[mbryson]

It's hard to tell from the pics, but the fabrication on the cage looks a bit sketchy. None of the tubes are even close to lined up with each other.

I think I'd start over with the cage and what not. Just looked like some reasonable sheetmetal?

 

[bryson]

It's hard to tell from the pics, but the fabrication on the cage looks a bit sketchy. None of the tubes are even close to lined up with each other.

You do realize it's a Bronco...Right?

The tub looks twisted-ish too. Clean, but twisted.

 

[mbryson]

You do realize it's a Bronco...Right?

The tub looks twisted-ish too. Clean, but twisted.

couldn't be from the cool fab work

I think Milner was looking to "de-buggy" his Bronco that hasn't been on the trail in 243 years? could be a decent solution for him?

 

[broncomitch]

Body is fine, cage is junk.
Rockers need to be replaced or cut out and it's missing the front clip.
I wouldn't pay more then $400-$500 for it if that's the only rust on it.

 

[bryson]

Body is fine, cage is junk.
Rockers need to be replaced or cut out and it's missing the front clip.
I wouldn't pay more then $400-$500 for it if that's the only rust on it.

You should buy it.

 

[Raleigh]

Why, he'd just destroy it anyhow!!!

 

[broncomitch]

Would be nice having a bed that's not full of holes

But I'm about to blow alot of money to link my front end so I better not. Lol