Garage sale time - this one is the best... I promise.

[bryson]

More stuff to move...

Call/Text preferred 8am-11pm. Trades considered.

-Bryson
801-949-5326

Stock TJ rear driveshaft - run 2 days after new joints were put in, and it was checked for balance. IIRC, it is 12" joint to joint. - $40

TeraFlex S/T single rate swaybar system for TJ - 2 bars, new end caps, new frame bushings, new knob... - $50 SOLD

Factory rear Ford SD overloads - $20
Front Dodge Dana 60 shafts from 01.5-02 truck WITHOUT disconnect axle - retro into your disconnect axle. - $20 SOLD

Small air compressor - NOT oilless! Works great. - $40 SOLD

NEW Corbeau seat sliders - $40 SOLD

Toy 22RE engine mounts and brackets - $20 for both SOLD
Trans mount - $20 SOLD

Weld-on heavy-duty TJ/XJ/ZJ lower control arm brackets - axle side - $10 for all 3 SOLD

 

[airmanwilliams]

air comressor a 4gallon?

 

[Herzog]

Interested in the Dodge D60 shafts

 

[mbryson]

Sway bar. Will that work for my YJ?

 

[bryson]

air comressor a 4gallon?

I believe so. I can check in the AM and I'll let you know for sure.

Interested in the Dodge D60 shafts

You know where I am.

Sway bar. Will that work for my YJ?

TJ and YJ frames are pretty similar up by the bumper, so I'm sure you could make it work... You are welcome to come get it and try... if it works, great, if not, I'll sell it to someone else. I also have some D300 parts you may be interested in.

 

[muleskinner]

I PM'd you about the seat sliders.

 

[bryson]

Just confirmed that the compressor is indeed a 4 gallon capacity.

 

[Kevin B.]

My baby compressor just starting spewing oil all over, so I'll take it if nobody in front of me pulls the trigger.

 

[airmanwilliams]

pm sent

 

[bryson]

I still have lots of parts here...

 

[bryson]

Weekend bump!

 

[I Lean]

Don't know if it still matters, but if I recall correctly, the TJ swaybar stuff will work on a YJ by turning the O.D. of the press-in frame bushings down some.

 

[mbryson]

Don't know if it still matters, but if I recall correctly, the TJ swaybar stuff will work on a YJ by turning the O.D. of the press-in frame bushings down some.

I believe you are correct. I have some "marring" on my tube that I need to clear up before stating that as fact but it appears you are correct.

 

[Coco]

Can you measure that swaybar? Wondering if it would be long enough for my buggy project? Maybe it will work for the rear of the F-Toy frame?

 

[bryson]

Can you measure that swaybar? Wondering if it would be long enough for my buggy project? Maybe it will work for the rear of the F-Toy frame?

It's gone... Sorry.

BUMP for the rest!

 

[bryson]

Still have a few parts left...