got some new protection....

[Skyetone]

My old sliders had finally broken the booger welds that held them to the frame. It was my first real project so I am surprised that they held this long.
So I tore em off and made new ones and desided to incorporate the front section of my "exo" cage. The rest will be added over winter. Money permitting.
I hate the look of exo's (yes ollie) so I desided to work around the problem.What do you think?

this is the finished look I wanted

This is without the fender

Bent up a little bar 1 3/8" to slide in the cowl

The basic idea of it sticking out pre trimming.

Inside and the wipers still work.

 

[Bones]

Sweet! You use a HF bender? I forgot to ask on the PBB thread

Also could you run no doors in UT and not get busted right and left? I don't want halfs, it's easy enough to pop mine on off

 

[Skyetone]

HF and 1.3/4 od pipe.
yea no doors is really bad.
Been stopped and asked about the doors and roof. but so far there is no utah state law against it.
Onr UHP said federal laws says no....

 

[Bones]

I gotta get my bender back and give this a shot.

 

[Skyetone]

just start a bend, move it three inches forward, bend a little, move it, bend ext. The JD's roll the bend in the distance of the bend, hf is in one place...

 

[Bones]

Yeap! Used both, the JD is painfully easy to use and make look good. The HF wil have to suffice for this though.