• RME Gear & Apparel

Hoarder Sale

neagtea

neagtea

Well-Known Member
Supporting Member
Location
farmington
Brand new CJ rotors for 81 and newer. 25.00 for the pair

Spring under unbolt skid plates 25.00 for 4

New YJ taiwan replacement windshield frame, has shipping dents thanks Fed-EX 40.00
Cj bikini's one used tan 10.00
Grey CJ/YJ windjammer 20.00
Brand new YJ safari top tan 30.00
CJ factory 6 cyl Tach 25.00
CJ Factory 8 cyl tach 25.00
Electric fuel pumps Holly blue/ carter and mallory 20.00ea
TH 350 core for 2 wheel drive. 40.00
Jeep 727 Core. 30.00
Jeep V-8 fenderwell headers (Cool Old School) 40.00

1.7 ratio big block chev roller rockers



Tons of other stuff I will update later.
Can text pics.
Let me know
 
Last edited:
Tacoma

Tacoma

Et incurventur ante non
Location
far enough away
Interested in the roller rockers, tell me more!!! Condition? Manufacturer? :D


Chrisman spools are pretty rad. :D Groovy old drag-race stuff. :D
 
neagtea

neagtea

Well-Known Member
Supporting Member
Location
farmington
Tacoma said:
Interested in the roller rockers, tell me more!!! Condition? Manufacturer? :D


Chrisman spools are pretty rad. :D Groovy old drag-race stuff. :D
Click to expand...

I will have to look at them I haven't opened the box in years.
The chrisman was in a TT diff. not as good as Gearworks stuff.

I need a 400 want to do some trading?
 
neagtea

neagtea

Well-Known Member
Supporting Member
Location
farmington
I don't recall the measurements on the chev but can look it up when I get some time. I have two pass side axles left not sure if they are chev or waggy.
I built a bunch of chev diffs so probably is one there.
 
H-K

H-K

INFIDEL
Supporting Member
Location
SLC UT, USA
Can you tell me more about those fuel pumps? Are they in-tank for a specific application or are they external/universal? PSI? thanks

Edit: Also the tubing notcher - is it the type that you use with a drill that uses holesaws?

Edit: Do you have enough spring perches/ubolts, etc to do a spring-over on a YJ?

Edit: 44 shafts for a full-width Ford reverse-cut? (sorry, don't have measurements, but if you need them I'll figure it out)
 
Last edited:
neagtea

neagtea

Well-Known Member
Supporting Member
Location
farmington
Fuel pumps for carb. External low pressure
Should have enough bolts and plates for S.O. depending on axle tube size. I think I only have a couple of perches though.
Yes HF holesaw notcher
 
H-K

H-K

INFIDEL
Supporting Member
Location
SLC UT, USA
I'll take that notcher.

I'm guessing the psi on those pumps is not enough to run TBI, but I might take one for a surge tank project I've been thinking about doing.
 
You must log in or register to reply here.
Top