Looking to drill out knuckles to 7/8s

[kmboren]

I am finally upgrading my steering to an over the top. I purchased a used Teraflex knuckle but need to drill the knuckles holes out to 7/8 to fit the new 1 ton TREs. I do not have a drill or a bit large enough to do this job. Does anyone mind helping me out or know of a place where I can have it done. I need a total of 3 holes drilled out, two on passenger knuckle and one on drivers side knuckle. More than willing to buy you lunch, favorite soda or some cash your way for your efforts. I am located in American fork but willing to Travel to southern Utah county or northern Salt lake to have it done. Thanks in advance
Kevin

 

[Gravy]

bring it over to my place if you ever are up in SLC

 

[kmboren]

Thanks stratton. Carl is making me a Tie rod and am going to have him Ream them rather then run and insert.

 

[Gravy]

Smart. I had problems with inserts until I welded them. I think Cory did too.
I actually have a reamer.... somewhere... hopefully it wasn't one of the things that got stolen... I'm still finding things I didn't notice earlier missing... lame.