Need help rebuilding eaton steering valve

[broncomitch]

I have a eaton steering valve (orbital valve) part #211-1049-002 and bought a seal kit for it.
http://www.ebay.com/itm/200293878541?redirect=mobile


I got the seal kit and took apart the valve but the check ball and a roll pin fell out and I CAN NOT FIGURE OUT WHERE THEY GO!!!


The instruction's that came with the seal kit dose not even show a roll pin or a second pin.


One of the 7 bolts has a bigger threaded hole with a adapter plug in it, but nothing behind it and the check ball just rolled out of it.


I called eaton but the guy I talked too was hardly any help and gave me a Australian number I can't call.. Any help will greatly apperachated!!


Roll pin in question...

My valve doesn't have parts 7-8-9-12-13

 

[broncomitch]

 

[broncomitch]

I got a email from the guy I got the seal kit from and a guy on pirate4x4 that said the ball goes in the hole fallowed by the pin and the bolt hold's them in the cavity.


When trying to figure it out the first time I put them in there like that but thought there was no way cus roll pins normally hold two parts together and the pin just flop's around in there?

but oh well, long as it work's. lol