Bones
Registered User
- Location
- Kansas City, MO
Okay, for those that don't know, here's a brief rundown.
86 4runner (22RE), flopped it, now it's an 87 Xcab. Removed the 4runner harness and used all of it in the Xcab (minus the rear widow garbage). Thought I had everything nailed down (marked everything when I removed it), connected the battery, turned the key....nothing. Had a loose cable, turned the key to acc. and there were gauge lights, and headlights. Then I tried to start it and blew a couple fuses. One under the hood for the horn (10A) and one in the fuse box (25A). Replaced both, went back to acc. to check out where I had power and nothing at all, no headlights nothing. Where I should start looking?
Long story short. I bought the 4runner, had it inspected back in 98? horn was dead. PO must have not wanted a horn cuz it was clipped off right at the plug on the horn. so I "rigged" it back together and it's been fine ever since. I may have lost the plug off the harness, which I could care less, I'd just solder ends on the bare wires and plug it in, but the wires on the harness are MIA as well. I need to remove the harness running along the rad. support to see if they got pushed against the metal.....see I'm solving problems just by typing..lol Now I wish I was home so I could go play detective..lol
Damn this is gonna get some chuckles.
86 4runner (22RE), flopped it, now it's an 87 Xcab. Removed the 4runner harness and used all of it in the Xcab (minus the rear widow garbage). Thought I had everything nailed down (marked everything when I removed it), connected the battery, turned the key....nothing. Had a loose cable, turned the key to acc. and there were gauge lights, and headlights. Then I tried to start it and blew a couple fuses. One under the hood for the horn (10A) and one in the fuse box (25A). Replaced both, went back to acc. to check out where I had power and nothing at all, no headlights nothing. Where I should start looking?
Long story short. I bought the 4runner, had it inspected back in 98? horn was dead. PO must have not wanted a horn cuz it was clipped off right at the plug on the horn. so I "rigged" it back together and it's been fine ever since. I may have lost the plug off the harness, which I could care less, I'd just solder ends on the bare wires and plug it in, but the wires on the harness are MIA as well. I need to remove the harness running along the rad. support to see if they got pushed against the metal.....see I'm solving problems just by typing..lol Now I wish I was home so I could go play detective..lol
Damn this is gonna get some chuckles.
