- Location
- Grand Junction, CO
Looks awsome Kurt! Are those 35" MT/R's?? Nice match! 
(Hey, did you get my PM about MRT?)
(Hey, did you get my PM about MRT?)
"Project Trail Trailer" Build Up
- Thread starter cruiseroutfit
- Start date
- Location
- Sandy, Ut
Greg said:Looks awsome Kurt! Are those 35" MT/R's?? Nice match!
(Hey, did you get my PM about MRT?)
Yup, so I have 3 spares...
PM? Let me check...
- Location
- Grantsville, Utah
I can't tell from the pic... but did you cross your safety chains? they are supposed to be crossed in the event that your trailer comes off the hitch, it will be supported by the crossed chains instead of dragging on the ground.
- Location
- Sandy, Ut
Hickey said:
Nope, not crossed.... can't I just cross them as I hook it up again?
- Location
- Grantsville, Utah
The chain that falls on the left side of the hitch should hook to the right side d-ring on your rig, and vice versa. It looks like you have plenty of chain to do it. When hooked up, they will cross each other as they pass under the tongue.cruiseroutfit said:
- Location
- Sandy, Ut
Hickey said:
Gotcha... Will do in the future... I should have plenty of chain, if not it is easy to add some more... Thanks for the heads up
James K
NO, I'm always like this
- Location
- Taylorsville, Ut
looks good, but I swear the trailer has bigger tires then the crusier
- Location
- Sandy, Ut
asau said:cruiseroutfit that trailer is awsome
Basically... the back 3/4 of the tub are made of fiberglass, and the front I used a set of quarter-panel replacment skins... so that all 4 corners have matching radius's... and the tob is two spliced together...