sixstringsteve
Well-Known Member
- Location
- UT
PLEASE READ THIS ENTIRE POST BEFORE RESPONDING
Ok, this is not your typical "part-out" thread. Here's the situation. I need to sell my Tacoma. The aftermarket stuff on it doesn't raise the value much, so I'd like to sell/trade it out for stock stuff, then sell it in a state that's closer to stock.
For sale, no swap needed:
- rear seats: Geo Tracker LSI seats, split, with mounting bracket and seat belts - $150
- rear shell: $250 (SOLD)
- Sleeping platform: $200 (Cost over $200 in parts alone). (SOLD)
- 4runner rear roll bar/canopy - modded to fit the bed of a tacoma/3rd gen pickup. So sad to see this go. $150
Trade your stock parts plus cash for these:
- 35x12.50x17 KM2 with Sequoia Wheels, 7,000 nukes on them - $1300
- rear bumper: $300
Once all the parts have been swapped, I'll be selling the truck in the following state:
1997 Toyota Tacoma
2.7L 4cyl 3RZ
177k miles
5 speed
newer Marlin Heavy Duty Clutch (has 15-20k on it)
20 MPG
best running engine I've owned
OME/Dakar rear lift springs and shocks
ubolt flip
brand new cat and flowmaster exhaust
Tubbed for 35's if you ever want to go to bigger tires
frame reinforced
4:30 gears in the diffs
ADD conversion
TRD tacoma rear axle with elocker
dual transfer cases & skid/crossmember
sliders
new wheel bearings, upper ball joints, and lower ball joints
$6500 FIRM
Ok, this is not your typical "part-out" thread. Here's the situation. I need to sell my Tacoma. The aftermarket stuff on it doesn't raise the value much, so I'd like to sell/trade it out for stock stuff, then sell it in a state that's closer to stock.
For sale, no swap needed:
- rear seats: Geo Tracker LSI seats, split, with mounting bracket and seat belts - $150
- 4runner rear roll bar/canopy - modded to fit the bed of a tacoma/3rd gen pickup. So sad to see this go. $150
Trade your stock parts plus cash for these:
- 35x12.50x17 KM2 with Sequoia Wheels, 7,000 nukes on them - $1300
- rear bumper: $300
Once all the parts have been swapped, I'll be selling the truck in the following state:
1997 Toyota Tacoma
2.7L 4cyl 3RZ
177k miles
5 speed
newer Marlin Heavy Duty Clutch (has 15-20k on it)
20 MPG
best running engine I've owned
OME/Dakar rear lift springs and shocks
ubolt flip
brand new cat and flowmaster exhaust
Tubbed for 35's if you ever want to go to bigger tires
frame reinforced
4:30 gears in the diffs
ADD conversion
TRD tacoma rear axle with elocker
dual transfer cases & skid/crossmember
sliders
new wheel bearings, upper ball joints, and lower ball joints
$6500 FIRM
Last edited:
