TJ Track Bar Mount

[TJustin]

I am installing an aftermarket TJ Track Bar and I cannot get a wrench on the back side to get the bolt off... what do you do, the wrench doesn't fit in the slot where I have access to the nut.


HELP!

 

[RockChucker]

is this the axle side? if so, the nut should, (should being the key word) have a plate on it that acts as a wrench so you can just loosen the bolt. if that is missing, my best advice that i can think of is to stick a welder in there and tack the nut to the bracket so it doesn't move. i did that to a buddy's and it worked out pretty well. you might also try using some vice grips on the nut that have a long snout kinda like needle nose pliers. good luck.

 

[salaciouscrumb]

I ended up in the same situation that your in, and decided that using a torch to cut the opening slightly bigger would work the best. That was more than 3 years ago, and i'm still glad I did it that way...much easier when you need to service it.