toyota clutch hookup in a sammy?

[O'neal]

I started on my junker zuk right before winter hit,going for a full yota swap.I Got the body off,cut in half,trans tunnel cut to fit tranny-cases up inside tub,yota motor mount's welded in place,and a transfercase mount made.Now all I have to do is put it back together as soon as it get's warmer,since I've got to work on it outside.
Now one problem I need to figure out,Hooking up the clutch.since the zuk is cable and yota's are hydrolic,I figured i'd put in my spare booster out of an 83 toy,that way I could run my brake's and clutch off of that,Has anybody done this or have any link's that could help me out?

 

[cheapzuk]

I would take the toyota clutch M/C and fabricate it to run off the stock clutch pedal. I would keep it seperate from the brake system so if you have a problem in one system than you will still be safe.

i.e. if you break a line in the brake system you can still push in the clutch.

 

[O'neal]

I would take the toyota clutch M/C and fabricate it to run off the stock clutch pedal. I would keep it seperate from the brake system so if you have a problem in one system than you will still be safe.

i.e. if you break a line in the brake system you can still push in the clutch.

You got a point.Thank's