nvrstsfyd
Donating Member
- Location
- American Fork
Just installed on 85 p/u pulls to right. Anyone know what I need to adjust to align properly? Do I have to much toe-in or out? Any advice Thanks!
Toyota High steer alignment
- Thread starter nvrstsfyd
- Start date
BCGPER
Starting Another Thread
- Location
- Sunny Arizona
Sounds like your toe in is out of whack, since that's about all you can adjust on it. You'll have to shorten (or lengthen) your tie rod accordingly.
KToy
Well-Known Member
- Location
- Herriman, UT
which highsteer kit did you do ?
and you should be able to adjust the tierod and draglink with the TRE and also is your power steering box aligned ?
and you should be able to adjust the tierod and draglink with the TRE and also is your power steering box aligned ?
nvrstsfyd
Donating Member
- Location
- American Fork
KToy said:
Sky-manufacturing & the box is aligned.
KToy
Well-Known Member
- Location
- Herriman, UT
before an alignment i like to get my tires rotated and balanced. but bigger tires are harder to do. maybe rotate your tires and see if it still pulls.
Easiest way to do a driveway alignment - get two thumbtacks, stick one in the outer tread block of each front tire halfway up the tire from the ground. Measure the distance between the tacks in the front, then roll your truck backwards until the tacks are in the center at the back of the tires, and measure the distance there. Adjust your toe-in and repeat the measurements. I think toys need about 1/8" to 1/4" toe in, so when the measurement with the tacks in front is 1/8" to 1/4" less than the measurement in the rear you should be good. Look up the toe-in specs to be sure though, it's been a long time since I did mine.
- Location
- Sandy, Ut
DToy said:
Thumbtacks... thats a good idea... I use chalk, but thumbtacks are cooler
