Wanted NP204 from a chevy 32 spline

[dodgezilla]

Hello, I'm in need of a good working np205 from a chevy (passenger side drop) with the 32 spline input shaft. I've been told that this was the t-case was behind a th400 trans in the early 80's.

 

[AaronPaige]

I have 4 maybe 5 205 Chevy t cases where you at?

 

[dodgezilla]

I'm in Pleasant Grove UT. I'm happy to come get it if you have a 32 spline big bearing unit.

 

[AaronPaige]

I'll go count splines on my way home about 4 today, do you need round bolt pattern or figure 8

 

[dodgezilla]

It looks like either the round or figure 8 bolt pattern will work. If you can determine the front output shaft spline count a 30 spline unit would be preferable.

On this page you can see a picture of the 32 spline output. It's the one on the left. I believe the 32 spline short output is the desired one.
http://goo.gl/Ruq0bh

The ORD site says the common short 32 spline found from behind a th400 can be identified by the fact that it sticks out of the case about 1 1/4".
Thanks

 

[AaronPaige]

i have 2 mounted to 700r s and one to a th350 both I'm guessing would be 27 spline and 2 with or from a manual trans, looks like no 32 spline(not in use) at the moment sorry, but I'll keep watching for more, I'm looking for a 80s one ton and won't need the t case so I'll keep you in mind

 

[AaronPaige]

I have one more I have not checked in storage I'll check it too

 

[dodgezilla]

Thanks for checking and I will keep my fingers crossed.

 

[AaronPaige]

My last one to check is 27 spline as well sorry to get your hopes up...