Search results

8" (1.75") surplus supply ram 1.5 ID I swapped a Durango Saginaw box on my big TJ. Lines from Evco house or hose. I run a wagoneer pitman arm to match my steering arm length. I used to make a new billet aluminum replacement front cap that was tapped for lines and then I tapped the top cap...

I was on the U4WDA board a decade ago when we did this. But I wasn't much part of the paperwork. Maybe try Big Sarge Matt Westrich

It's a standard d44 hub so whatever that is. Maybe 3" - 4" backspacing

I think 20"s are too big for 35"s. Maybe a nice wheel I can do both with.

WJ is 5x5" pattern (same as the JK / JL) And the center bore isn't big enough for a locking hub. I need 5x5.5" (sometimes known as 5x139.7mm)

I'd like to update the look of my Jeep and I need a set of five on five and a half inch bolt pattern 5x5.5" 16 or 17-in Wheels. What do you have?

Nice! We just bought an acre in Eden and spent the weekend up there. The colors were great! Especially over North Ogden pass.

I can go ride tomorrow. I'd like to see if my back is up for the race I pre-register for this s Saturday! @jeeper you in?

Tedo does it on his truck. It looked great

Cleverrrrr! I especially like the ziptied coil isolator. That's mint.

Edelbrock Performance mask.

@Coco triggered. :rofl: Love ya 😘

Sidewinder was fun. I was delighted at how good my (small by 2020 standards) TJ was on big stuff.

About done loading up. See y'all in the morning!