Search results

yup its free! come get it, if you bring me a Dr. Pepper I'll be your friend.

"They do not cease to play because they grow old, they grow old because they cease to play." NEVER GROW UP, IT'S A TRICK! I've watched my (little) kids start to make friends, and I wish we as adults were as easily entreated as them. Do you all remember that one special aunt or uncle in your...

I'm sure there's a tuner for them already right?

I'll take them.

I've got a v6 3rd but it's 4.30

The tail cone and output shafts are the only differences. Unless you get a different case. The full size truck K case is stronger than most 2wd cases.

I'm heading up tomorrow to scope it out. I'll snap some shots of the damage

I should be there. I've been to every one since before it was called Old School.. I love it!

Haha! Getting offended over a welder joke is like getting mad someone doesn't like the same kind of music... I'm Glad airgas could fix it. I've learned from experience. I had an Everlast unit. 2 actually. Welder and plasma cutter. Parts availablility was next to zero and it was down more than it...

Buy once cry once. Friends don't let friends but Everlast

Pictures are better than words . . . . . . . . . . . . . . . . . . . Ta-Da!

Notes: 2002 YZ125+19 Base line 420 main 30 idle. 32:1 67°F 390 main 5000' elevation 2.5 out air screw 30 idle 6chy5 79 needle 2nd clip might need 1st clip or leaner needle.

Torx+ Now pre-rounded!

Fabrizio Scalvini just wept a tear of beauty over that bike. You are a champ. What a dad to take care of you daughter like that. What a mess. I'll call you later and tell you my story of 2 stroke woe.

Sorry Russ. That Acerbis tank is HDPPE. And while you can try to fix it with PlastiWeld or plastic radiator tank fix it JB gas tank patch...ultimately the only fix that works is melting the crack together with a soldering iron. And because it's where that brass shroud bolt insert is located...

Sorry I guess I was confused, I didn't realize you were measuring your lash with the shims you already had in there. When you said zero lash I was assuming you were measuring without shims in to get your baseline. It is my experience, however, that new valves will require a thicker shim than...

Ditto what Bart said. I pieced one together about 9 years ago for my wife's YJ with B||/ RBV parts and she broke it on 31s unlocked.

Their algorithms aren't very good but I use it all the time because of the shear volume, it's a lot of wading through garbage sometimes but it's huge. I think you'd be surprised at how much marketshare Facebook Marketplace has taken over from CL and KSL. Look it up. It's VERY substantial.

I made this goofy shifter 9 years ago. And it didn't have enough friction in the shifter to stay in gear on the rear output until I swapped in heavier detent springs and new unworn detent balls.