1" drill bit

[ChestonScout]

I know this is in the wrong section but Im hoping for a little more traffic :greg:


I need a 1" drill bit to drill out one hole on a high steer arm


Anyone have one I can use for a few minutes?


I dont want to buy one for one fetching hole :-\

 

[big cherokee]

i have a one inch hole saw if that would help any

i will see if i can round up a drill bit also

 

[ChestonScout]

dont think a hole saw would cut it....


Its a 1/2" thick high steer arm that has a tapered hole for a tie rod end in it already. Just need to ream it out

 

[bobmed]

I have one

 

[Bucking Bronco]

I have one (I think)

 

[Chevycrew]

I have some at work, should be for a 1/2" chuck as well.

 

[I Lean]

I have one if you happen to find yourself in the Magna 'hood.

 

[big cherokee]

i used my hole saw to cut out my d ring plates for the front of my truck

it did great

but a bit would work better since you have nothing to center the hole saw with since there is a hole all ready there.

 

[ChestonScout]

Sounds like I will be borrowing one from Steve (Bucking Bronco)

Thanks for the help guys!