Anyone have an adjustable reamer that I can borrow?

[sixstringsteve]

I need to ream two holes from 16mm to 17mm. Does anyone have an adjustable reamer set, or a 17mm drill bit?

5/8 is too small, and 11/16 is too big. I need .67 inches (17mm)

I thought about buying the set from harbor freight, but it's $80, and I can't afford that just to ream one hole.

Anyway, let me know if you've got anything that'd fit that description

 

[sixstringsteve]

anyone?

I'll probably buy a set at HF tomorrow if I can't find any locally.

 

[Corban_White]

Steve, is HF open on the 4th? If you want to wait till tuesday it looks like industrial supply might have a 17mm drill bit. If not they have a 21/32 and they might have a 43/64.

http://catalog.indsupply.com/category/?category=Cutting+Tools%2FDrill+Bits%2FJobbers

http://www.csgnetwork.com/drillsizeconvert.html

They are in Orem on the west side of the fwy. Good luck.

 

[sixstringsteve]

Thanks for the tip Corban. a 43/64ths reamer or drill bit would work really well. a 21/32 would be too small. supposedly HF has a 25% off coupon tomorrow, so the set will only cost me $60 instead of $80. I'm guessing a nice reamer at an industrial store would run $40-60 anyway.

 

[ricsrx]

text sent

 

[sixstringsteve]

rick, you rock. you always pull through for me at the last second, right when I need ya. I'll hit you up tomorrow.

 

[MikeGyver]

Under $10 shipped on ebay, but slower. http://shop.ebay.com/i.html?_nkw=43...&_sticky=1&_trksid=p3286.c0.m14&_sop=15&_sc=1

 

[sixstringsteve]

we'll see how it goes tomorrow. Hopefully i can borrow rick's drill bit in the morning then you can weld the tabs on for me. If I can't get that to work, I'll go to HF and get their adjustable reamer set.

 

[mierdota]

I have a ball joint reamer that might work or I have a ton of drill bits too

 

[sixstringsteve]

it's a tapered reamer, right? I need a straight reamer. Thanks though.

 

[sixstringsteve]

thanks again Rick. Your 43/64ths drill bit was perfect.