Anyone work on forklifts?

[Cody]

I've got an older Toyota propane forklift that's running like shit. It's always been a little cold blooded to start, but would idle and run fine once started. Now it won't idle for more than about 15 seconds without dying, and if you aren't on the pedal it wants to die on you. Might just be a tune up or carb adjustment, but I know nothing about them and honestly just don't have the time to try and figure it out.

Anyone looking for sidework? I don't have a ton of cash, but could manage some cash and/or beer for help.

 

[Hickey]

Wish I could help cuz I like your beer, but I don't know jack about propane motors. I've heard they are quite simple, though.

 

[Gravy]

Start with plugs and a carb clean.
If it doesn't have an auto choke focus on the choke circuit.

 

[4x4_Welder]

I've had a few of those mixer regulators gunk up with the yellow crud in propane. They are also much more sensitive to low compression and will lose a ton of power below about 150psi.