Bucking Bronco
................
- Location
- Layton
I needed to bend some 1.5" Tube and I have a 1.75 Die for my tube bender. I don't bend enough to pay a couple hundred for a Die so I made this.
It worked Better then I expected. I place this inside the 1.75" Die effectively changing it to a 1.5" Die
I first bent 1.75" tube
Then I cut it in half. I need to clean it up a bit but I want to see if it would work first
And here is the bend in the 1.5"
It worked Better then I expected. I place this inside the 1.75" Die effectively changing it to a 1.5" Die
I first bent 1.75" tube
Then I cut it in half. I need to clean it up a bit but I want to see if it would work first
And here is the bend in the 1.5"