First build.

[Jeep80CJ7]

not too much done in the last year. Here's what I got, finished passenger floor frame, most of the roll cage, and reinforced joint where rear frame was stretched.

 

[Tacoma]

Any reason you don't run that rear diagonal to the rocker and make a pretty triangle??

I like this garage build.

 

[Jeep80CJ7]

Any reason you don't run that rear diagonal to the rocker and make a pretty triangle??

I like this garage build.

Which tube are you referring too?

 

[Tacoma]

The diagonal that runs through the welder in the pic. In the drawing you have it going where I'm referring to, but on the vehicle it's orphaned into the middle of the B pillar.

 

[Jeep80CJ7]

Honestly I did that cause I had a long left over piece of tube after cutting the b pillar and one of the side hoops out of a 20 foot stick. Cut the piece in half and that's where they ended up. I plan to tie that section in with the door way and the door way to the stinger. like in this picture.