Jeep Hickey’s 1995 Jeep Wrangler YJ

[STAG]

I really liked my Teraflex D30 balljoints.

 

[kmboren]

I'll have to keep an eye on this build, I have a Lunchbox in my D30 and a Grizzly in my 8.8 in my YJ The grizzly is way smoother on road. If I were to start over again I'd probably toss an ARB or Ox up front

Same set up we have in our YJ. We did the Yukon 8.8 c clip eliminator kit also. A XJ dana 30 to eliminate the vacuum deal on the YJ dana 30.

 

[Tom95YJ]

I really liked my Teraflex D30 balljoints.

Same here I havnt had issues with them at all

 

[Tom95YJ]

Same set up we have in our YJ. We did the Yukon 8.8 c clip eliminator kit also. A XJ dana 30 to eliminate the vacuum deal on the YJ dana 30.

I have chromoly shafts in my 30 but I did run the XJ shaft for a long time, I have the Rare Reid D30-to 44 Outters that I have not installed yet with Warn hubs and Yukon Stubshafts an Artec highsteer arms/ double shear kits for when I get around to going soa I just need to gather the parts to build a Antiwrap bar an I'll get it done.

 

[Hickey]

I have chromoly shafts in my 30 but I did run the XJ shaft for a long time, I have the Rare Reid D30-to 44 Outters that I have not installed yet with Warn hubs and Yukon Stubshafts an Artec highsteer arms/ double shear kits for when I get around to going soa I just need to gather the parts to build a Antiwrap bar an I'll get it done.

I was looking at steering knuckles online last night. JK units are stupid cheap. Maybe I should just look for a JK Dana 30 someone is tossing out, and narrow it for my front axle.

 

[Gravy]

Moogs joints are $59 a pair so $118 bucks. Is $200 lots?

I see no issue with lifetime warranty vatozone Balljoints with that size tire.
I ruined unit bearings 3:1 before ball joints on my last stockish 30.

 

[Hickey]

Moogs joints are $59 a pair so $118 bucks. Is $200 lots?

I see no issue with lifetime warranty vatozone Balljoints with that size tire.
I ruined unit bearings 3:1 before ball joints on my last stockish 30.

Moog is not good enough for me, and I’ll eventually get larger tires on this ride. I don’t care about a lifetime warranty if it means I have to replace the parts more often.

 

[Gravy]

Which was why I was confused if you were saying $200 was a lot for aftermarket, seems like $82 is only a very little for more (albeit very little more) strength.

 

[Hickey]

Which was why I was confused if you were saying $200 was a lot for aftermarket, seems like $82 is only a very little for more (albeit very little more) strength.

I was saying they are expensive as compared to equivalent JK joints.