• RME Gear & Apparel
  • Side-Jobs Forum Rules:
    • No requests related to 4x4, offroad, or any services already provided by vendors who support RME and make this site possible. If you are seeking these types of services, please post in a General 4x4 or another approriate forum.
    • No requests related to morally questionable or illegal activities
    • Any requests here may be removed at any time at the discretion of the moderators

Machining Round Bar

D

DakarNick

Member
Hi, all. Looking for someone to mill or even bandsaw-cut two flats onto a 12.00" long by 1.50" diameter bar. The flats would be 6.00" long on opposite sides of one half of the bar, .250" deep.

I'm in the SE Denver area. I know this is a Utah/Western Colorado-based site but thought I'd ask anyway!
 
You must log in or register to reply here.
Top