4x4_Welder
Well-Known Member
- Location
- Twin Falls, ID
D60 rear, 4.56 gears, open, from a 70s Chevy (not sure on spline count) complete $50
D60 rear, 3.73 gears, open, from 72 F250, needs brakes and a wheel seal, otherwise good. Still under the truck, getting swapped out in two weeks. $100
Jeep/GM front rotors and calipers, in serviceable condition, $50 have a new set of pads too.
Jeep D44 front low pinion 3.08 gears, gears and carrier only, $20
75 Jeep Wagoneer NT long side shaft inner and outer, $25
BW 1356 from 88 F350 short slip output (had two piece shaft with rear slip joint) worked fine when pulled, $100
Ford power steering box from 88 F350 4x4, $75
91 or 92 4Runner steering box, unknown condition, complete with pump and lines $50
94 Nissan Pathfinder steering box, good shape, $50
Jeep/AMC 6cyl head, fits up to 80 model year (1/2" head bolts) rebuilt with about 500miles on it $150
York compressor, fresh off the engine, $50.
NP435 and D21 case from 72 F100, no bellhousing. NP is thoroughly used, both are covered in oil. $75
I'm sure there's more, but that's what I can think of now. All parts are located in Rexburg, ID but I can meet semi-locally, and I am moving to Oregon so I can drop off along the way.
D60 rear, 3.73 gears, open, from 72 F250, needs brakes and a wheel seal, otherwise good. Still under the truck, getting swapped out in two weeks. $100
Jeep/GM front rotors and calipers, in serviceable condition, $50 have a new set of pads too.
Jeep D44 front low pinion 3.08 gears, gears and carrier only, $20
75 Jeep Wagoneer NT long side shaft inner and outer, $25
BW 1356 from 88 F350 short slip output (had two piece shaft with rear slip joint) worked fine when pulled, $100
Ford power steering box from 88 F350 4x4, $75
91 or 92 4Runner steering box, unknown condition, complete with pump and lines $50
94 Nissan Pathfinder steering box, good shape, $50
Jeep/AMC 6cyl head, fits up to 80 model year (1/2" head bolts) rebuilt with about 500miles on it $150
York compressor, fresh off the engine, $50.
NP435 and D21 case from 72 F100, no bellhousing. NP is thoroughly used, both are covered in oil. $75
I'm sure there's more, but that's what I can think of now. All parts are located in Rexburg, ID but I can meet semi-locally, and I am moving to Oregon so I can drop off along the way.