- Location
- Grantsville, Utah
Jeep Need suggestions for replacement 4.0 for a TJ
- Thread starter Hickey
- Start date
- Location
- Grand Junction, CO
Looks like fun! That new block is PURDY!!
gijohn40
too poor to wheel... :(
- Location
- Layton, Utah
love that engine stand on the cart!
- Location
- Grantsville, Utah
I thought about buying an engine stand, but I figured I would use it once and it would clutter up my garage for the rest of my life.
Jinx
when in doubt, upgrade!
- Location
- So Jordan, Utah
You do have friends that would lend you one if you asked.
- Location
- Grantsville, Utah
But I just made one, and it doesn't feel like it's gonna break or tip over either!
- Location
- Grantsville, Utah
Your temporary engine mounts look better than a lot that are in use daily, on people's rigs.
They are certainly the best ones I've made so far!
- Location
- Grantsville, Utah
- Location
- Grand Junction, CO
So exciting, congrats!!! Need to do anything else to get it driving?
- Location
- Grantsville, Utah
Tighten a few things up like belts and battery clamps. Install the winch power cables. A handful of minor things.
- Location
- Grantsville, Utah
- Location
- Grand Junction, CO
That's good to see! I'll be curious to know how it feels after it's broken in, with the bump in compression.
- Location
- Grantsville, Utah
He said the clutch already feels tighter and smoother. We didn't change the clutch, but we rubbed the flywheel down with a sanding block and torqued the pressure plate to spec.