Need tread plate sheared

[StormRider]

I've got 2 pieces of .06 aluminum tread plate I need trimmed, the largest edge is 63 inches. Anyone have shop recommendations? I'd prefer south/west side of the salt lake valley.

 

['03_RUBI]

All Steel Fab. 3037 South 3600 West in West Valley. I believe he is "WaterJetGuy" or something similar on here.

 

[I Lean]

If a plasma cut edge is clean enough, bring it over and we can slap it on the table. 63" is just fine, as long as it's less than 54" the other dimension.

 

[EB101]

.060 cuts good with a saw. If it's simple straight cuts, you can always dig out your table saw with that fine tooth carbide blade.

 

[Caleb]

Even a skil saw will cut that no problem. To make it even easier, just clamp a straight edge on and run your saw down it. You can cut pretty dang thick with a simple skil saw (we used to do 3/8" all the time even).

 

[bobsled84088]

exact fabrications 79 west 4500 south murray
801-261-9599

 

[Bart]

I cut 5/8s alum with a skil saw and it worked great.

 

[StormRider]

Thanks guys. A J Sheet Metal in sandy took care of me for $6

I know a circular saw would have worked, but a shear is so much simpler.

 

[EB101]

Thanks guys. A J Sheet Metal in sandy took care of me for $6

I know a circular saw would have worked, but a shear is so much simpler.

You'd be hard pressed to beat that! And you don't even have to clean up filings.