Resurfacing Flywheel $

[Tallz]

Does anyone know what I can expect to pay to have my flywheel resurfaced?

Also, does anyone know of a good maching shop to do the work in Sandy, UT area?

 

[DOSS]

I don't know either but I have one that needs to be done as well so I am going to have to watch this

 

[193kyle]

Last one I had done was about $35 if I remember correctly.

 

[Tacoma]

i need mine done tooooo

 

[hillbillysteve]

I think you can have them done at checker for about $35

 

[DOSS]

I think you can have them done at checker for about $35

Don't know if I would trust my flywheel to checker monkeys...

 

[cruiseroutfit]

Parts Connection on 98th & 7th east, great guys.

 

[Lifelong Jeeper]

I paid $20 to shop on 300 W and 1700 S (ish). I can't remember the name but they specialize in flywheels, crank/cam shaft grinding, as well as heads, block machining. their building is just north of Young Electric Sign Company's parking lot.

 

[MikeGyver]

$15 for a harbor freight angle grinder

 

[Shawn]

$30.00 at Napa.

 

[sixb]

20.00 for a cummins fly wheel at six states/parts connection 17th south and around 247 west recently.

 

[Tallz]

Parts Connection on 98th & 7th east, great guys.

Yeah I have been there before and had good luck there with some parts on my 14 bolt rebuild. I have seen their machine shop and was impressed, but I figured why not ask on here and just make sure there is nothing really better. And, they are litteraly around the corner. Decision made!

Thanks

 

[grandmaster]

I know at my work down here in St. George we charge 30. I wouldn't bring it to checker either hahha. Take it somewhere where they know what they are doing, if not it will just mess up your clutch evenutally. Especially if it is a 2 step, they are a bit harder to grind and get within spec.

 

[jester]

X2 My work takes ours to six states and they do really good work.