ten factory axle shafts? anyone running them?

[gijohn40]

broke a shaft in my LJ dana 44 last night and was looking into these to upgrade my axles... just wanted to know if anyone else has them and their opinion.

 

[cjncustoms]

I have the 35 spl stubs in my 60. They're going on 5+ yrs and no complaints.

 

[BlueWolfFab]

Nate just broke one down in St George

 

[gertsch]

I have them in my 30. Had them since 2011. Twisted the splines recently on the passenger shaft. Sent then a pic of it and my receipt. Had a new shaft to my door within a few days.

 

[zmotorsports]

I am running Ten Factory axle shafts in the rear of my JKUR and my son is running Ten Factory in the front Dana 30 axle of his LJ. They seem to be a well built axle shaft from what I can tell. I have had mine for around 40k miles and my son's LJ probably around 4 or 5 thousand is all.

Mike.

 

[N-Smooth]

Nate just broke one down in St George

Yup, just broke one in my 29 spline 8.25
I put it in a place I shouldn't have and it let go. It's taken plenty of abuse over the last few years for sure and it was like $75 so I'll get another one.

 

[gijohn40]

a complete set (both sides) are running about $289 now a days.... at least that is what I have found them for...

 

[UFAB]

Ten factory are like nitro gear

Import 4340 is as good as any other vendors like G2