• RME Gear & Apparel

The Official Tube Bending Thread

M

mdgillette

New Member
Hey guys, I need some suggestions on attaching my seats to the rollcage in my Jeepster Commando. The seats were yanked from a CRX, so they have odd mounts on nice sliders. I plan to add tubing from the existing A pillars to the existing B pillars of the cage, and between the B pillars as well. Would love to see some picture examples of mounting tabs, etc.
 
B

Baileigh Inc

New Member
Location
Manitowoc, WI
mdgillette said:
Hey guys, I need some suggestions on attaching my seats to the rollcage in my Jeepster Commando. The seats were yanked from a CRX, so they have odd mounts on nice sliders. I plan to add tubing from the existing A pillars to the existing B pillars of the cage, and between the B pillars as well. Would love to see some picture examples of mounting tabs, etc.
Click to expand...

Do you have any pictures you could post up?
 
cheepin

cheepin

Active Member
Location
Parachute Co.
mdgillette said:
Hey guys, I need some suggestions on attaching my seats to the rollcage in my Jeepster Commando. The seats were yanked from a CRX, so they have odd mounts on nice sliders. I plan to add tubing from the existing A pillars to the existing B pillars of the cage, and between the B pillars as well. Would love to see some picture examples of mounting tabs, etc.
Click to expand...
In our Jeepster I used 1.5 square tube.Goes from A-pillar to B-pillar.Then has 2 crossbars side to side.The sliders are then bolted to these.Very simple and easy.Ran the crossbars just above the floor tunnel.
 
You must log in or register to reply here.
Top