The_Lobbster
Well-Known Member
Looking for a Wagoneer D44 pass drop axle, from my research it should have a wms measurement right around 59" or so.
Thanks!
Thanks!
Wanted Wagoneer D44 pass drop axle
- Thread starter The_Lobbster
- Start date
- Location
- West Haven, UT
I have a passenger drop (front) wagoneer axle, it measures approximately 61.5" WMS. There might be a "narrow-version" of the axle, but I haven't seen it.
More discussion:
Wagoneer front axle width?
The front D44 I have for my Willys came from a Wagoneer, and I was under the impression it was close to 62" wide WMS-WMS, which is a bit wider than I'd like it to be to match my rear Toyota axle at 58". As I looked around for axle shaft lengths, (contemplating narrowing) I ran across this...
www.rme4x4.com
The_Lobbster
Well-Known Member
Open or closed knuckle? Price if you want to sell? Or is it in your rig?I have a passenger drop (front) wagoneer axle, it measures approximately 61.5" WMS. There might be a "narrow-version" of the axle, but I haven't seen it.
More discussion:
Wagoneer front axle width?
The front D44 I have for my Willys came from a Wagoneer, and I was under the impression it was close to 62" wide WMS-WMS, which is a bit wider than I'd like it to be to match my rear Toyota axle at 58". As I looked around for axle shaft lengths, (contemplating narrowing) I ran across this...
- Location
- West Haven, UT
Nothing for sale - just commenting on the WMS as you might not have it right
The_Lobbster
Well-Known Member
Gotcha! I suppose I need to do some more research. My rear axle is 59.5”, so 61.5” is probably not too bad. Trying to get everything in order to keep busting out this project I got.
DaveB
Long Jeep Fan
- Location
- Holladay, Utah
Here is a part out on KSL: https://classifieds.ksl.com/listing/73869025
The_Lobbster
Well-Known Member
I contacted them. That unit is a closed knuckle, and doesn’t appear to be a 44 cover. They have some more wagoneers though and are going to check for the correct axle.