- Location
- Grantsville, Utah
Congrats! I'm glad you found the problem, and that it was a simple one.
Where/how do you have your CB mounted in your TJ?
- Thread starter DAA
- Start date
- Location
- West Bountiful, UT
After putting the hard top on and tuning the antenna, the final numbers ended up between 1.1 on CH1 and 1.4 on CH40. I'm well pleased with that. And it really seems to recieve better than my old radio. Been quite the PITA, but I'm real happy with it now that it's finally done!
- DAA
- DAA
Grimmjpr
New Member
- Location
- Salt Lake City, Utah
Sweet.....are you using the 3 footer or the 4? did you get another firering cable or a standard type coax? Just wonderin......Glad its working good for you now...
- Location
- Grantsville, Utah
I have to wonder if your mount is so solid, that all of the flex is transferred into the stud. You might consider a beefy acorn style stud to spread the load.
- Location
- West Bountiful, UT
Steve, using the 4 footer and a regular PL connector coax from Flying J. I SWR tested it with the 3' patch cable before final install and it didn't like that, so I drilled a hole in the tub right above the tailight to cut a couple feet off the routing so it would be long enough without the extension. It had a removable end like the Firering, so the hole is small (with a rubber grommet).
I wouldn't doubt that at all. That mount I made is way stout. I'd almost bet the stud would yield before it would.
- DAA
I wouldn't doubt that at all. That mount I made is way stout. I'd almost bet the stud would yield before it would.
- DAA