waynehartwig
www.jeeperman.com
- Location
- Mead, WA
I doubt Ben will waste your money...
who straightens 60 housings??? HELP
- Thread starter SICK99TJ
- Start date
I doubt Ben will waste your money...
Tacoma
Et incurventur ante non
- Location
- far enough away
Oh. Well, I'm no help to you. These would be low-pinion GM housings. 
Wonderboy
Member
- Location
- Murray, Ut
So how much did you found out it would cost to retube it? I found an axle, but it would need new tubes as well.
waynehartwig
www.jeeperman.com
- Location
- Mead, WA
He's having a new one made... I sent Rocklogic a Currie RJ HPD60 center and they are pressing tubes in and transfering parts.
Wonderboy
Member
- Location
- Murray, Ut
What would pressing new tubes in and adding all of the brackets and parts run?
waynehartwig
www.jeeperman.com
- Location
- Mead, WA
Through me? Depends on what brackets you want and I have a inner knuckle out to reuse or if I'm doing new inner knuckles out.
The center, tubes and Dedenbear KP inner C's are $1200 + shipping. From there you can add your outer knuckle out, gears, axles, etc. I prefer to make the housing around a set of OEM shafts - then you don't have to make them special, but I can do whatever you want.
Wonderboy
Member
- Location
- Murray, Ut
It would actually be for a rear axle.
waynehartwig
www.jeeperman.com
- Location
- Mead, WA
I'll send you a PM. We are already hijacking his thread...