_Auzzy_

Next I’ve been fiddling with the ram mounts and truss ideas and we finally came to these. Got the ram up in place but realized off the...

Little update, been plugging away on the rear diff some more! Random pieces, made little grease fittings for the wheel bearings and...

Frenched in the front spring hangers on the CJ project. I also layed on some molten steel. May need some touch-up work on my...

Don’t worry gents I’m currently training an an alcoholic rabid raccoon to bite nuts that we will leave for him in his work truck next...

So, we gonna spam the comments on that video and call them out or no?

Is this your buddy? I was watching the video and noticed your handiwork, then I listened closer when he said his name and remembered...

They stole pictures from my build thread lol. I better be getting a royalty check lol.

Here’s the one I plan on running. Had an aluminum one that claimed to be 12.5k rated but noticed it had cracks around the pin holes for...

I’d be tempted to throw my grand cheapokee in if it’s allowed being that I purchased it for $1200

Hucking junkers off a cliff isn't what I intended at all, I want to wheel these things and continue doing so.

Almost forgot to show these beauties off. Cory laid down some amazing welds as per norm, even with the material being thin and on edge...

I'd even suggest to run a few feet less than full capacity too - less worry about the rope bunching up on the drum and causing issues...

Knocked out my steering cooler, 2.5”OD x 25”L x 1.5”ID 6061 aluminum. Fins are .100 thick with .125 gaps, took out 5/16” of material...

Next we got some aluminum work going on. Got my trans cooler fan shroud made. Just need to tack my spider on and send it to powder...