perfect. I'll try removing the relay and see what that does for the abs. as for the brake light, my ebrakes are still disconnected cause the axle i got had cut cables, so i'm guessing that's why that light is still on. i'll put new cables in and see if that goes away.
I have a 2000 XJ that I swapped the Dana 35 for a 8.25. The 35 had abs and the 8.25 does not. I unplugged the wiring for the abs (two separate clips) and the new axle did not have anything to replace it with. So how do I get the e-brake and ABS light to turn off?
So I bought an XJ recently and it had about a 4.5" lift on it. I put a long arm kit and a 2" coil spacer in the front. I was going to do a shackle lift but it was already done. I noticed the rear leaf pack has hardly any arch in them, and am not sure if they are after market or not. I was...
I just bought a 2000 xj and was replaced the two oxygen sensors but I still get a check engine light. Hooked up the scanner and it says Circuit High Voltage bank 1 sensors 1&2. Any idea's what that means or how to fix that? I'm told it's cause it's running too lean.