Search results

Just added photos

Yes all of the hardware is accounted for. I will need to snap a few photos of it along with a bunch of other stuff I need to sell.

I just changed out the Big Daddy steering box bracket in my Scrambler to fix an issue with tie rod interference due to the latest changes I have made on my Scrambler. The bracket is very stout and has worked well, I just went with one that moves the steering box forward. Low miles driven by a...

My son has an extra set of four, I'll ask him if he will part with them.

When we need to find thermal problems with the electronic circuits we design we use a heat gun and freeze mist. Warm the radio circuit boards up with a heat gun till it starts to work then freeze the components with the freeze mist till you find the parts or circuit board area that kills the...

Good talking with you yesterday, my son should be back in town today or tomorrow if you want to text him.

I have some XJ clusters if you can use them.

Sold

If you want an axle upgrade I have a custom dana 60 that was in a late 90's GMC 1500 truck that should fit. It has an ARB and moser shafts. It does have 4.56 gears so that would require a change.

Most snow blower problems are gummed up carbs since they sit for so long not being used. They are usually a pretty easy fix.

I'll try.

Two of them (a Honda and a Toro) need carb work. Both leak gas because the float and needle valve aren't shutting things off.

I currently have 5 snow blowers and need to fix some up and sell them.

It is back on the road and looks like it is working just fine. Now I need to thaw out, fixing stuff outside in this cold is a pain.

The fitting is in a housing that doesn't allow access from the back side. I hopefully fixed it tonight. I took one of the ends off the old hose and made a tap out of it. I split the fitting much like the tool in the picture above then pinched the cut end giving it a taper like a tap. I then...

I messed up some threads in a very expensive hydraulic fan unit on my Grand Cherokee and have been looking for a way to fix the threads which are only messed up on the first two threads. I found that they make a slick tool to take care of the same problem in aluminum cylinder heads. You insert...

Bump, lowered the price

There should be a third connection on the switch which would go to ground. Just make sure you use an ohm meter to determine which one is the light connection and which is the 12V switched feed. The light connection will show a connection to the switched terminal of the switch when open and to...

Burbot are a member of the cod family and are very good to eat.

I have bent the 1.5" .25 wall on my HF bender by heating it up with the torch first. On my son's Jeep the track bar I made for his high steer took some bending and it worked out well with heat. You can come use my bender if you want.