Search results

I drive a Bronco also

Thanks for all the info. I was talking about the needle bearing in the spindle. just hoping that is the problem. Where is a good place to get good quality bearings?. I tow a mini X and dump trailer rolling 22000. lbs. Timken? Napa? Frank Edwards?

Dose anybody know about replacing hub bearings in the front axel of a F350? I have heard that you can replace the needle bearings that are the main problem with out replacing the whole hub. I have been told that there is a NAPA Bearing that fits, but can not confirm it in all the searching i...

Thanks for the info. Thanks I'll giv them a call :)

I wonder if anyone has heard of a way to Shave Down Tires that are severly out of round? I have a set of Mt/Rs' and two of the four are cupped out baddly. I have access to a fork lift and we lifted the rear axel off the ground and smoked them pretty good and it helped but..... dose anyone...

Cam PM you for me I have two sets I reallyt need to get sold. I removed them off a Lincoln Continental and they accept vented rotors up to 1.25"s thick. I have the mounting brackets and hardware for them as well. I researched the rebuild kits($12.00 Each) and core charges($80.00 Each) and new...

Thanks for the additional info.

Thanks for the info! Do you know where I can get a axel shaft that uses the typical 44 U-joint?

Whats the difference between an Early Bronco Dana44 front axel and a full size Dana44 out of a chev/Ford? Besides the obivious difference in track width, do they use the same U-joints? Axel joints? What is the length of the inner shafts?

I have room for leaf springs but havent decided on any thing just yet. I just need to keep costs low and the axel I have has the gear set that I need to match the 9" rear that I have. I would like to find an early Bronco 44 front and then I would just run coils again

Not pulling both out I guess thats true on the fact that I only need to pull one side. But, I would need to find more axel tube to make the long side. Can U buy that stuff? I have been looking for a waggy front 44 with the drivers side drop for a long time. $250 is the cheapest I have ever...

Dana 44 swap Thanks for the info on that! I contacted them and it's seems to be a little more costly than just buying a waggy front 44 Is there any body that has done this that can tell me how to do it? I have access to presses and other machine tools just need some advice. Do the tubes...

I have a Front chev Dana 44 that I would like to convert over to a ford drop! I want to narrow it and put it under a Bronco II. Any body Know any bodythat dose this sort of crazy thing?