Search results

If thats the case I might have a title and vin plate that will work. I would have to look at what I have.

Looks like a CJ7 to me!!

pm sent

1995

So I have a Fab Fours bumper on the back of my TJ. Last weekend while playing in the snow the spindle snapped. It was just a single shear design. I have purchased a new spindle and hub in a double shear design. It uses a standard 1000 lb spindle like everybody else does. Has a double shear...

I trust the hitch to handle the weight. I also trust the that the fancy locking pin will get rusted up and the hitch will be junk. I used to run a Anderson rapid hitch with their stainless locks. I tow a lot and would leave it in. I had to make sure I took the locks out multiple times during...

I had a guy come in yesterday for a emissions test. As I was taking his info he asked if we could take a minute and check the brakes. He said I check my lights. I check my tires. I know that stuff is fine. But while it is in the shop can you check my brakes. I think you will see two things...

My atv trailer weighs just under 700 pounds also. It is probably just shy of 1000lbs Never have registered my atv trailer. Never will register that trailer. No cop cares enough to question and make you unload a trailer.

I installed one for a customer a couple months. He provided the motor. It came with all oem gaskets and spark plugs. It was complete minus intake. Seemed like a nice rebuild. Did one on a Hemi 6 months ago that used a generic Victor gasket. I can find out who he got it from.

I have ordered a larger trailer so my current trailer needs sold. Deck is 22 foot long. It is the superwide/buggy hauler as PJ calls them. So it has drive over fenders with a 102 inch wide deck, It has dual 7K axles so 14k gvwr. Powder coat is still in good shape. Tires are in good shape and...

Now thats a work bench!!

np 231 is ATF AX15 I run amsoil Manual Trans Fluid

I dont think you can put the scope directly in water. I have never tried though. The scope itself is only 2 feet long or so. It probably would not be very helpful for scoping a drain.

No sorry I forgot about this post. It is sold.

So I have a Teraflex transfer case drop kit that came with my kit. I installed it and readjusted the pinion angle and still had the shake. I then pulled the rear driveline out and had Six States double check the balance on it. It was a little of balance but more than likely not my issue...

There is a guy here in Logan that has it and loves it. He has had it on for a long time without any issues. He has the non intercooled version. I have been considering a Sprintex supercharger for my 2006 TJ

how much?

Im needing some cheap 2 inch budget boost spacers that I can install in my super low budget ZJ build.

I have a CJ7 with a 4.2 and Howell efi also. I considered a 4.0 swap at one point. I wanted more power and economy than the 4.0 offered. I also looked at a Vortec 4.3 swap. That is just about as much work and expense as a v8 swap. Mine is now getting a 5.3 GM If pops is not wanting more power...

My wife and I rode the 4 wheelers to these falls several years ago. The main road in from the highway. We stopped at the falls and played around. We then rode across the falls and followed the creek for a bit. The trail just kind of dies out. We meet a group of rigs that were driving the creek...