Search results

Id offer you my vacuum coolant filler from snap on but im down in hurricane ut. Might wanna see if someone near you has one. They work amazing.

If accuracy isn't a major concern just get the knockoffs on amazon. I think I got 4 for under 10 bucks shipped. Have them set around 10 psi but have see them go +-3 psi. I throw on all 4 drive slow for a minute or two and pull them off. Im usually just cruising the desert so it works ideally for...

Id look into your timing advance for the reason heat build up....not the cooling system. You might have to compromise between power and heat management unfortunately.

Awesome!!!!!!! Thanks for sharing!

Ive always had weird things with my dash. Volts reading low even though alternator is putting out 14+-, oil pressure always high, etc. I wonder if we could hard wire a resistor to bypass batt temp to make alt put out constant voltage??? What should the correct resistance be on a new batt temp...

It is absolutely acceptable to space it out with washers. Much better then over torqueing or just putting in the cotter key way above the castellation. 90% of hardware on my helicopters are torqued that way.

Tip of the day???: Found this out recently and I love it.... RuGLYDE rubber conditioner. Sold at napa. Use it during tire removal and install as a lubricant. Makes the job so easy, soft on hands, wont rust or hurt rubber/metal/tube, cleans rubber, etc. 15$ for a gallon. Put it in a spray bottle...

built one a few months back. Pretty simple if your mechanically inclined. Must have good set of snap ring pliers and some healthy 2-3 jaw pullers. There are lots of writes up online but I found the illustrated parts catalog and paying attention did more for me. Id do a full rebuild not...

Ive got one for ya. where you located? IM in STG. I have two bastard packs you can take some from.

Looks good!! Wish I could have joined you. That steep crawl to enter the fault line has got my wife yelling at me too. Btw pirate4x4 has a some great writes for hydro assist. Also look into the Durango steering box swap if your into something alittle more mellow.

:cool::cool::cool:

These have been great post deathwobble life: https://www.ruffstuffspecialties.com/catalog/R1768.html https://www.ruffstuffspecialties.com/catalog/FIXIT.html

Ive got a 07 300xc that is in near perfect shape. Lets make a trade!!!!

14 bolt shave kit?

Can do. Ill post when I know my dates for sure

Thanks to a member on here im doing a parts run in the next week or so.4/6-4/13 Probably be in a midsized car but could take the Yukon (trailer$$$) if someone bwill pay for some gas. Let me know if yall need anything.

Awesome. Sending you a PM.

Knuckles in ok shape? would take it all off your hands. Price? In woods cross?

Looking for knuckles and housing up to complete assembly. Let me know what you have. For an XJ.

Don't up it! Youre probably already lean like stated above. Leave your mix ratio and jet next step rich.